Indiana Radon Mitigation: Permits and Contractor Requirements

Contractor Certification in Indiana

Indiana has significant Zone 1 counties, particularly in the southern half of the state. ISDH estimates that approximately 40% of Indiana homes have radon above 4 pCi/L.

Regardless of state licensing requirements, always verify that any radon contractor you hire holds current NRPP certification (nrpp.info) or NRSB certification (nrsb.org). These national certifications require passing a written exam and adhering to AARST ANSI installation standards.

Permit Requirements

Indiana does not require a statewide building permit for radon mitigation in existing single-family homes. An electrical permit is typically required at the local level when a new circuit or outlet is installed for the radon fan. Confirm with your local building department before work begins.

Radon Zones in Indiana

Indiana has counties in EPA Radon Zone 1 & 2. Zone 1 counties have the highest predicted average indoor radon levels. Even homes in lower-zone counties can test high — the only way to know your home's actual level is to test it with a certified test device.

What Indiana Homeowners Should Do

1. Confirm your test result. At or above 4 pCi/L on a confirmed long-term test, proceed with mitigation. At 8+ pCi/L, act without further delay.
2. Find 2–3 certified contractors. Search NRPP at nrpp.info or NRSB at nrsb.org for Indiana-based certified mitigators. Get written quotes.
3. Confirm permit requirements. Ask your contractor: "Will you pull an electrical permit if new wiring is needed?" Confirm with your local building department.
4. Schedule installation. Standard SSD installation takes 3–8 hours. Typical cost in Indiana: $800–$2,000.
5. Post-mitigation test. Wait 24–48 hours after installation, then run a radon test. Target: below 4 pCi/L, ideally below 2 pCi/L.

Frequently Asked Questions