Contractor Certification in Kansas
Kansas has Zone 1 counties in the northern and eastern portions of the state. KDHE recommends testing all homes, particularly those in high-radon geology areas.
Regardless of state licensing requirements, always verify that any radon contractor you hire holds current NRPP certification (nrpp.info) or NRSB certification (nrsb.org). These national certifications require passing a written exam and adhering to AARST ANSI installation standards.
Permit Requirements
Kansas does not require a statewide building permit for radon mitigation in existing single-family homes. An electrical permit is typically required at the local level when a new circuit or outlet is installed for the radon fan. Confirm with your local building department before work begins.
Radon Zones in Kansas
Kansas has counties in EPA Radon Zone 1 & 2. Zone 1 counties have the highest predicted average indoor radon levels. Even homes in lower-zone counties can test high — the only way to know your home's actual level is to test it with a certified test device.
What Kansas Homeowners Should Do
- Confirm your test result. At or above 4 pCi/L on a confirmed long-term test, proceed with mitigation. At 8+ pCi/L, act without further delay.
- Find 2–3 certified contractors. Search NRPP at nrpp.info or NRSB at nrsb.org for Kansas-based certified mitigators. Get written quotes.
- Confirm permit requirements. Ask your contractor: "Will you pull an electrical permit if new wiring is needed?" Confirm with your local building department.
- Schedule installation. Standard SSD installation takes 3–8 hours. Typical cost in Kansas: $800–$1,900.
- Post-mitigation test. Wait 24–48 hours after installation, then run a radon test. Target: below 4 pCi/L, ideally below 2 pCi/L.
Free Download: Kansas Radon Homeowner Checklist
Step-by-step checklist covering testing, permits, contractor selection, and post-mitigation testing. One printable page.
Download Free PDF